Video signal interface: Parallel RGB or serial.LCD Driver IC: HX8264D x1 & HX8664B x1.Amorphous-TFT 5.0 inch display, transmissive, normally white type.The LCD adopts one backlight with High brightness 12-lamps white LED. This single-display module is suitable for use in Multimedia Player products. USB port Display replaces the HDMI/NTSC output, therefore DPI HAT and HDMI won’t be working simultaneously and you won’t be able to switch between the two.Same as the EEPROM I2C pins, or hardware SPI pins. UART RX/TX pins (no console cable) and standard user I2Cpins are not included.
Pins are hardcoded, so they cannot be moved or rearranged. This add on board uses almost every pin available on the Raspberry Pi. What does that mean? It means that it gets all the graphics acceleration capabilities as well as immediate refresh which you would normally get from an HDMI display. Kippah screen is what is called ’native’. When tested the results showed that this can be used with 5’’and 7’’ displays at 800x480. This Kippah has not got a touch screen, however, you will get a sleek ultra-fast 18-bit colour display with optional touch support. With a little software configuration, what normally would go out the HDMI port, now will come up on a nice little flat screen. This Adafruit DPI Kippah has a TFT panel which is connected to a Raspberry Pi without the use of on HDMI decoder.
0 kommentar(er)
